|
The Dana/Spicer Model 44 is an automotive axle manufactured by Dana Corp. and is used extensively among automobile manufacturers and in the automotive aftermarket area as well. The Dana 44 was first manufactured in the 1940s and is still being manufactured today, both front and rear axle variants. The Dana 44 has been manufactured as a beam axle and independent suspension for both front and rear axle setups. There are also different variations of the Dana 44. Over a dozen automobile manufacturers have made vehicles that feature Dana 44 axles, including Jeep which currently manufactures Four-wheel drive vehicles that feature both front and rear Dana 44 axles. ==General specifications== * Ring Gear measures * Ring Gear measures * OEM Inner axle shaft spline counts are 10, 19, 29, 30, 32, 33 and 35 * Pinion shaft diameter: 1.375" (most dana 44's) 1.625" (JK rear 8.9" dana 44's) * Pinion shaft splines and spline diameter: 26/1.12" (most dana 44's post 1970), 24/1.25" (JK), 10/1.12" (early pre 1970 dana 44's) * Gear ratios range from 2.72:1 to 5.89:1 * Carrier break: 2.72:1 – 3.73:1 and 3.92 – 5.89:1. 6.17:1 (Volvo C202) On some differentials only the high speed 2.72–3.73 carrier is used for all gear sets up to 5.89 (JK, Nissan or when thick gears are used) * Axle Shaft diameter * *1.175” Front outer (19 Spline) * *1.20” Rear (10 Spline) * *1.30” Rear (19 Spline) * *1.31” Front inner (30 Spline) * *1.31” Rear (30 Spline) * *1.41" Rear (32 Spline) 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Dana 44」の詳細全文を読む スポンサード リンク
|